Here is what you can do to your nice Alinco DJ-V5T Radio!
There are a few nifty tricks to make some operating adjustments to the Alinco DJ V5T. Below you will see what you need to do to make some operational adjustments that do not require opening the radio at all. All operational adjustments are readily made by an access code on the keypad. Before performing these adjustments please make sure you write down every setting code indicated in the LCD display area when preparing to adjust so you can restore it back factory defaults if you need to.
You can access the radio operational adjustment mode by doing the following:
1: With the radio turned on press the Func-Lock button for one second until radio is in keylock mode.
Enter this code: 490217
You will notice it will immediately advance into onboard adjustment mode, from here you can make the following adjustments. When making these adjustments use the up/down butons lable * and # on the keypad. Using these keypads will select your different adjustment options. Then once you are at an option you would like to adjust just turn the tuning dial to change values up or down.
Here is what you will see when in the adjustment mode on the Alinco V5-T.
In your display area you will see:
UFREQ (mine is set at 45)
UPO HI (UHF High Power Adjustment) Mine is set at 72
UPO L1 (UHF Low power audjustment) Mine is set at 45
VPO HI (VHF HI power adjustment) Mine is set at 79
VPO L1 (VHF Low power adjustment) Mine is set at 53
VMOD (VHF Modulation) Mine is set at 4A
UMOD (UHF Modulation) Mine is set at 45
VTUN L (VHF Receive sensitivity lower portion) Mine is 4E
VTUN M (VHF Mid-Frequency sensitivity adjustment) Mine is 71
VTUN H (VHF High-Upper frequency Receive sensitivity adjustment) Mine is 91
VSQL 1 (Lower squelch threshold adjustment on VHF) Mine is 95
VSQL 5 (Upper squelch threshold udjustment on VHF) Mine is 28
VSMT 1 (VHF Lower threshold adjustment) Mine is 34
VSMT 5 (VHF Upper threshold adjustment) Mine is 45
UTUN L (Lower UHF Receive sensitivity Adjustment) Mine is 72
UTUN M (Middle UHF Receive sensitivity Adjustment) Mine is 8A
UTUN H (Upper UHF Receive sensitivity Adjustment) Mine is AC
USQL 1 (UHF Lower squelch threshold adjustment) Mine is set at 8A
USQL 5 (UHF Upper squelch threshold adjustment) Mine is set at 16
USMT 1 (UHF Lower threshold adjustment) Mine is 3b
USMT 5 (UHF Lower threshold adjustment) Mine is 4C
WSMT 1 (Wideband lower threshold adjustment) Mine is 1C
WSMT 5 (Wideband upper threshold adjustment) Mine is 17
That is all for the adjustment modes.
To save changes and exit just press the number 0 on the keypad which will let your radio resume into normal operating mode once again.
|
