'LIGHT+FUNC' & SWITCH ON: Display test
'LIGHT+FUNC+V/M & SWITCH ON: Extended frequency range, 0 - 1310MHz,
enters multi function mode with new PT
status 'bA' for receive only, see PTT
function table below for detailed operation.
Tuning steps above 204MHz only 12.5KHz or
25KHz (channel number indicator changes from
U to last ch. no.??)
'LIGHT+FUNC+C' & SWITCH ON: Changes PT from 'bA' to 'P' and enters multi
function mode.
PTT function table
PT status P PL bA
Simple Mode:
~~~~~~~~~~~
(- TX, 144-146 TX, 144-146 (*) TX, 144-146
P - selects -( 'o.FF' other 'o.FF' other 'o.FF' other
(- --- --- ---
F&P - selects pwr low beep@ pwr
Multi Mode:
~~~~~~~~~~
(- TX, 144-146 low beep, high beep,
P - selects -(
(- --- frequency 100MHz steps
F&P - selects pwr low beep AM/FM toggle
Notes:
P stands for pushing the PTT switch, table shows in 2nd row also the result of simultaneous rotation of the tuning control, --- = no reaction.
F&P stands for pushing FUNC,PTT; pwr stands for low/high toggle and for stepping by tuning control, ref. to Instruction Manual.
- PT status selection via SET/PRIVATE mode, ref. to Instruction Manual.
- PT status 'bA's only available for extended frequency range (after execution of 'LIGHT+FUNC+V/M' & SWITCH ON), memory contents remain unchanged (approx. working range of ext. band is 75...365MHz).
- Amateur frequency range can only be recovered by 'RESET', => 'LIGHT+MON' & SWITCH ON, all memory contents will be lost!
(*) THIS OPERATION IS NOT IN ACCORDANCE WITH INSTRUCTION MANUAL, P. 30 - PL SHOULD LOCK PTT (TX DISABLED) ALSO IN SILE MODE!
|
