Display test / Rx Expanding;
Turn the porto off, press the #,3 and the B, hold this buttons, now turn on
your porto (Red Button), you will see now all the functions who are in the
lcd display.
When you quit pressing the #,3 and the B button, your porto can now go
(On Display) from 100khz <> 999.90Mhz at the 2m Display, and on the 70cm
Display he will go from 100khz <> 1310.00Mhz, of course he will not recieve
from 100khz <> 1310Mhz, but the low vfo receive at least from
126Mhz <> 190Mhz, the high vfo receive at least from 390Mhz <> 999Mhz, with
some steps between 390Mhz <> 999Mhz where he not receive signals, because
the vfo is out of his lock.
Enter Freq via keyboard;
When you enter a freq (in vfo mode) by pressing enter (ENT) you will see
that you can press only the last 3 digits, this is simply to change by
pressing the function button (above the ptt) and the set (8) button, push
now with the ^/scan until you see on the display 'PL', now you can dial
1 - 10 -100 = 1Mhz - 10Mhz - 100Mhz, set this option to 100 (dial), now
you press the clr (*). Done !!!!
If you now press enter (#) (in vfo mode) you will see that you now can
press the whole freq. The same for the other vfo, this go's the same for
1Mhz - 10Mhz PL function.
Steps with the dial;
Dialing a freq go's with steps in Khz, by pressing the function key
(above the ptt) the steps will be now steps of 10Mhz.
Here are some RX reports by JBE;
RX Freq Sensitivity (12db sinad)
-------------------------------------------------
126MHz - 111dBm
136MHz - 123dBm
145MHz <*** Main ***> - 125dBm
160MHz - 123dBm
174MHz - 110dBm
190MHz - 67dBm Low vfo
-------------------------------------------------
390MHz - 108dBm
430MHz <*** Main ****> - 124dBm
452MHz - 105dBm
470MHz - 103dBm
485MHz - 104dBm
850MHz - 110dBm
900MHz - 116dBm
925MHz - 114dBm
935MHz - 112dBm
950MHz - 107dBm
999MHz - 96dBm Hi vfo
-------------------------------------------------
|
