Modification procedures for models to other Type
(Transmitter band expansion, ext)
Set a desired destination by adding or deleting three chip jumpers
(R659, R661, R662) and a lead jumper (W602) on the foil side of the
TX-RX unit (X57-586X-XX). (Refer to the attached tables 2 to 19 for
details.) [Didn't get a copy of those].
- Remove R659 and W062 to extend the transmitting band.
- Remove R675 to modify the channel display mode. [Shows channel
instead of frequency?]
- Remove R674 to modify the repeater.
(Repeater in TM-D700A to U.S.A./Canada has already been modified
before factory)
Another note not from Kenwood.
I have looked at the board and cannot find R674, however there are tow
chip resistors (0 ohm?) labeled REPEATER and CH. Ay a guess these are
R674 and R675 respectively. I may try to remove REPEATERS later and
watch the results.
Usual caveats in place, if it breaks because of these mods, you are
on your own.
|
