This transceiver is capable of receiving signals on one
band and retransmitting signals on the other band. This function repeats
signals originating from one band, using the other band. For example, a
signal received on band A (VHF) is retransmitted on band B (UHF).
Similarly, a signal received on band B (UHF) is retransmitted on band A
(VHF).
Access Menu 1-7-6 (REPEATER) and select Locked" band Repeater or
Cross-band Repeater. The default is "OFF".
Looked-band Repeater
The transceiver always uses the same band to receive or transmit a
signal as a repeater. Belore accessing Menu 1-7-6, select one band as
the TX band and the en other band as the control band.
Cross-band Repeater
If receiving a signal on the TX band, the transceiver switches the
current RX only band to the TX band. Before accessing Menu 1-7-6, select
the same band as the TX and control bands.
82
If necessary, you can cause this transceiver to remain in the
transmit mode for 500 ms after signals drop. Access Menu 1-7-5 (REPEATER
HOLD) and select "ON".
Note:
- You cannot activate tbc Repeater function after recalling the same
frequency band (VHF or UHF) on band A and B, or while blanking a band
display.
- Activating the Repeater function switches OFF Automatic Band
Change (A.B.C.) automatic Simplex Check (ASC).
- The Time-Out Timer is locked at 3 minutes.
- After activating the Repeater function, you cannot access Menu
Nos. other than 1-7-5 and 1-7-6.
|
