It's correct: to close the jumpers 1,2,3 and opening the others ?
The second method sayed:
- pad 1 is already shorted with a chip resistor - NEGATIV ON MY TRX !
- short pad 2 and 3 with solder ... check pad 6 and if it has a chip resistor remove it ...
Here are my factory-settings in FT-847:
pad 1 = open
pad 2 = shorted with a chip resistor
pad 3 = open
pad 4 = open
pad 5 = shorted with a chip resistor
pad 6 = i'm not shure if open or closed, only a big solder-point
I'll send also a foto of my factory-jumper-settings
I'm happy about any detailed information !
|